Mugen MBX8 115mm Center Drive Shaft. This optional center dog bone eliminates friction and creates a more efficient drivetrain, increased acceleration and more traction compared to the stock universal driveshafts.
This is a pack of two optional Mugen 1mm MBX8 Graphite Rear Lower Arm Plates. These plates attach to the suspension arm to increase stiffness. Mounting hardware not included.
This is a replacement Mugen Front Upright, and is intended for use with the Mugen MRX5. This upright can be used on either the Right or Left side of the car.
This is an optional Mugen Big Bore Rear Damper Spring Set, and is intended for use with the Mugen MBX. These springs are made with 1.5mm wire making them slightly lighter than the previous springs, and feature an improved coil design which will make both your buggy and truggy much more stable through bumps and jumps.
This is a set of aluminum clutch shoes, and come stock in the Mugen MBX5 and MBX6 buggy kits. These aluminum shoes tend to hit harder than the black or white shoes with little slip
This is an optional Mugen Big Bore Rear Damper Spring Set, and is intended for use with the Mugen MBX. These springs are made with 1.5mm wire making them slightly lighter than the previous springs, and feature an improved coil design which will make both your buggy and truggy much more stable through bumps and jumps.
This is a pack of four replacement Mugen Shock End Steel Balls, and are intended for use with the Mugen MBX7 1/8 scale nitro buggy. These balls are directional. Be careful about the direction during installation.
This is a set of two hard front shock springs from Mugen and are intended for use with the Mugen MBX6. These springs are 75mm in length, and have 9 Turns.
This is a set of replacement plastic ball ends for the Mugen MBX truggy. These are used for the steering linkage and connect the front hubs to the steering ackerman