E0517 Mugen Seiki Front Shock Shaft (2)
€9.51
This is a pack of two replacement front shock shafts for the Mugen MBX7 and MBX5T truggy.
MBX8WE
Spares for Mugen MBX8WE Nitro 1/8 Off Road.
E0135-B Mugen Seiki Suspension Arm Spacer Set
€6.54
This is a replacement Mugen Suspension Arm Spacer Set, and is intended for use with the Mugen MBX7 1/8 scale nitro buggy.
C0265 Mugen Seiki 2.5x15.8mm Universal Joint Pin
€2.65
This is a set of replacement joint pins for the universals used in the Mugen MBX5 buggies, and are used to hold the universal joint together and go through the axle shafts and the joint shaft.
E0545 Mugen Seiki Damper End Set
€8.13
This is a replacement Mugen Damper End Set, and is intended for use with the Mugen MBX family of 1/8 Scale vehicles. This set includes four shaft ends and four spring cups.
E0717A Mugen Seiki 0.95mm Clutch Spring Set (3)
€7.40
This is a set of optional Mugen 0.95mm Clutch Springs. The stiffer the spring, the later the clutch will engage allowing the engine to spool up to a higher RPM range before the clutch comes on.
E2108 Mugen Seiki Complete Bushing Set
€11.30
This is a replacement Mugen Complete Bushing Set, and is intended for use with the Mugen MBX7 1/8 scale nitro buggy. This complete set includes all of bushings used in the suspension mounts to adjust toe angle, kick-up and anti-squat on the vehicle.
E2242 Mugen Seiki HTD S6 Silicon O-Ring (10)
€5.41
This is a pack of ten replacement Mugen HTD S6 Silicon O-Rings for use with the HTD (High Traction Diff) Differentials
E2267 Mugen Seiki Spur Gear 45T (HTD)
€48.37
E2267 Mugen Seiki Spur Gear 45T (HTD).
E2232 Mugen Seiki HTD Differential Case
€10.49
This is a replacement Mugen Differential Case for use with the optional HTD (High Traction Diff) Differentials.
E2116 Mugen Seiki Rear Hub Carrier Hinge Pin (2)
€13.74
This is a pack of two replacement Mugen Rear Hub Carrier Hinge Pins, and are intended for use with the Mugen MBX 1/8 scale nitro buggy. These hinge pins secure the rear hub carrier to the rear arm.
E2241 Mugen Seiki HTD Differential Gasket (10)
€9.51
This is a pack of ten replacement Mugen HTD Differential Gaskets for use with the optional HTD (High Traction Diff) Differentials.
E2805 Mugen Seiki Throttle Linkage Parts Set
€8.37
This is a replacement Mugen Throttle Linkage Parts Set, and is intended for use with the Mugen MBX7 1/8 scale nitro buggy.
C0264 Mugen Seiki Universal Joint Shaft
€3.74
C0264 Mugen Seiki Universal Joint ShaftThis is a set of replacement joint shafts for the universals used in the Mugen MBX5 buggie
E0240 Mugen 1mm Wide Offset Wheel Hubs
€9.76
This is a set of two Mugen 1mm wide offset wheel hubs and are intended for use with the Mugen MBX6 1/8 scale buggy.
E2168 Mugen Seiki Carbon Front Upright Arm (-3mm) (2)
€18.29
The Mugen Carbon Front Upright Arms offer improved initial steering response, and makes the vehicle more stable through the middle and exit of the corner. They also help to reduce bump steer and make the vehicle more predictable in bumpy conditions.
E2564 Mugen Seiki MBX8 Shock Retaining Pin (4)
€10.28
This is a pack of four optional Mugen Seiki Big Bore Blank Shock Pistons. Create your own custom piston hole sizes with these blank pistons.
E2712 Mugen Seiki Engine Mount Washer Set (4)
€5.16
This is a pack of four replacement Mugen Engine Mount Washers for use with the MBX8 line of nitro vehicles.
E2506 Mugen Seiki Rear Shock Boot (4)
€9.51
This is a pack of four replacement Mugen Rear Shock Boots, and are intended for use with the Mugen MBX7 1/8 scale nitro buggy.
H0274 Mugen Seiki 2.5x11.8mm Roller Pin (10)
€4.59
This is a pack of ten replacement Mugen 2.5x11.8mm Roller Pins, and are intended for use with the Mugen MRX4X 1/8 scale on road car.
H0471 Mugen Seiki Rear Body Mount Arm Pin (4)
€4.23
This is a pack of four replacement Mugen Rear Body Mount Arm Pins, and are intended for use with the Mugen MRX5 and MRX4X 1/8 scale on road cars.
E2252 Mugen Seiki MBX8 Straight Cut Bevel Gear (12T)
€13.90
This is an optional Mugen 12 Tooth MBX8 Straight Cut Bevel Gear.
E0811-B Mugen Seiki Rear Upper Arm Link (Long)
€4.80
This is a the new optional long rear upper arm link that comes with the Mugen MBX buggy kits.
E2262 Mugen Seiki MBX8 115mm Center Drive Shaft
€10.41
Mugen MBX8 115mm Center Drive Shaft. This optional center dog bone eliminates friction and creates a more efficient drivetrain, increased acceleration and more traction compared to the stock universal driveshafts.
E2421 Mugen Seiki MBX8 Front Bumper
€7.40
This is a replacement Mugen MBX8 Front Bumper.
E0161 Mugen Seiki Front Track Width Adjustment Spacer (4)
€5.20
This is a set of replacement Mugen front track width adjustment spacers, and are intended for use with the Mugen MBX6 and MBX6T 1/8 scale vehicles.
C0751 Mugen Seiki 0.9mm Clutch Spring Set (3)
€4.72
This is a set of stock 0.9mm clutch springs. This is the most common clutch spring for the Mugen MBX5 buggies.
E2147 Mugen 1.5mm Trailing Front Hub Carrier Set
€11.22
This is an optional Mugen Seiki 1.5mm Trailing Front Hub Carrier Set that can be used with CVA (MUGE0221 & MUGE0224) and universal driveshaft on all the MBX family of buggies, trucks, and GT vehicles. Package includes one left and right side, as well as four inserts.
E2310 Mugen Seiki Aluminum Servo Saver Arm
€18.13
This is an optional Mugen Aluminum Servo Saver Arm, and is intended for use with the Mugen MBX7 1/8 scale nitro buggy.
E2516 Mugen Front Damper Spring 1.6 L70/9.25T: X8, X8T
€13.00
Mugen Seiki 70mm Front Shock Spring Set (Soft - 1.6/9.25T) (2).
E0710 Mugen Seiki Aluminum Clutch Shoes (3) (Hard)
€30.57
E0710 Mugen Seiki Aluminum Clutch Shoes (3) (Hard)
C0601/1 Mugen Seiki 8x16x5mm Bearing (10)
€20.32
C0601/1 Mugen Seiki 8x16x5mm Bearing (10)
E2253 Mugen Seiki MBX8 Straight Cut Bevel Gear (13T)
€13.90
This is a replacement Mugen 13 Tooth MBX8 Straight Cut Bevel Gear. This is the standard Bevel Gear included with the MBX8.
E2156 Mugen 1mm MBX8 Graphite Rear Lower Arm Plate (2)
€19.19
This is a pack of two optional Mugen 1mm MBX8 Graphite Rear Lower Arm Plates. These plates attach to the suspension arm to increase stiffness. Mounting hardware not included.
FP2151 FP Aluminum One Piece Wing Button: MBX, Associated, Xray
€12.19
FP2151 FP Aluminum One Piece Wing Button: MBX, Associated, Xray.
E2260 Mugen Seiki MBX8 Center Joint Cup
€10.49
This is an optional Mugen MBX8 Center Joint Cup.
E0705 Mugen Seiki Flywheel Washer/Spacers (4)
€3.09
This is a set of four replacement Mugen Seiki Flywheel Washer/Spacers, and are intended for use with the Mugen MBX6 family of 1/8 scale vehicles.
E2261 Mugen Seiki 84.5mm Center Drive Shaft
€9.35
This is the optional Mugen Front Center Dogbone for the MBX8 and MBX8 Eco buggies. The center dogbones will eliminate friction from the stock universal driveshafts.
E2420 Mugen Seiki MBX7R Chassis Weight (40g)
€17.68
This is an optional Mugen 40 Gram Chassis Weight. This weight mounts to the back of the front gearbox or in front of the rear gear box on the MBX7R and MBX7TR nitro vehicles.
C0702B Mugen Seiki Flywheel Taper Cone
€3.98
These are replacement 3x13.8mm joint pins for Mugen buggies and fits the MBX5 family of buggies.
E2504 Mugen Seiki Shock End Steel Ball (4)
€7.97
This is a pack of four replacement Mugen Shock End Steel Balls, and are intended for use with the Mugen MBX7 1/8 scale nitro buggy. These balls are directional. Be careful about the direction during installation.
E2505 Mugen Seiki Front Shock Boot (4)
€9.51
This is a pack of four replacement Mugen Front Shock Boots, and are intended for use with the Mugen MBX7 1/8 scale nitro buggy.
C0753A Mugen Seiki 1.10mm 3-Shoe Clutch Spring Set (3)
€4.72
This is a set of stock 1.1mm clutch springs. This is the most common clutch spring for the Mugen MBX5 buggies.
E2137 Mugen Seiki 2.8mm Front Anti-Roll Bar
€10.16
This is an optional Mugen 2.8mm Front Anti-Roll Bar. This bar is slightly thicker than the standard 2.7mm bar included with the MGT7 and MGT7E.
E2803 Mugen Seiki Steering/Throttle Servo Horn & Parts Set
€4.80
This is a replacement Mugen Steering/Throttle Servo Horn & Parts Set, and is intended for use with the Mugen MBX7 1/8 scale nitro buggy.
E2138 Mugen Seiki 2.5mm Rear Anti-Roll Bar
€10.16
This is an optional Mugen 2.5mm Rear Anti-Roll Bar.
C0801H Mugen Seiki Steering Rack Bushings (2)
€3.81
This is a set of replacement steering rack bushings for the Mugen MBX5 family of buggies. These are the bushings that go into the steering ackerman plate, and connect the ackerman plate to the steering uprights.
E2422 Mugen Seiki MBX8 1-Piece Wing Stay
€11.99
This is the Mugen MBX8 1-Piece Wing Stay Set, including the wing stay, wing stay brace and four plastic wing buttons.