This is a set of replacement joint pins for the universals used in the Mugen MBX5 buggies, and are used to hold the universal joint together and go through the axle shafts and the joint shaft.
This is a replacement Mugen Complete Bushing Set, and is intended for use with the Mugen MBX7 1/8 scale nitro buggy. This complete set includes all of bushings used in the suspension mounts to adjust toe angle, kick-up and anti-squat on the vehicle.
This is a set of replacement joint pins for the universals used in the Mugen MBX5 buggies, and are used to hold the universal joint together and go through the axle shafts and the joint shaft.
This is a pack of two replacement Mugen Rear Hub Carrier Hinge Pins, and are intended for use with the Mugen MBX 1/8 scale nitro buggy. These hinge pins secure the rear hub carrier to the rear arm.
This is a replacement Mugen Damper End Set, and is intended for use with the Mugen MBX family of 1/8 Scale vehicles. This set includes four shaft ends and four spring cups.
The Mugen Carbon Front Upright Arms offer improved initial steering response, and makes the vehicle more stable through the middle and exit of the corner. They also help to reduce bump steer and make the vehicle more predictable in bumpy conditions.
This is a set of optional Mugen 0.95mm Clutch Springs. The stiffer the spring, the later the clutch will engage allowing the engine to spool up to a higher RPM range before the clutch comes on.
These front upper suspension arms have been shortened 1.6mm in length. This will allow the use of the MUGE0161 spacer between the pillar ball and the upper arm. This will allow for the same camber on each side of the buggy.
This is a replacement Mugen MBX8 Gear Box. This gearbox has been updated to allow you to remove and service the differential without detaching the suspension arm mounts.